tag:blogger.com,1999:blog-6573615209338157347.post3892342014553761887..comments2019-11-27T09:04:19.762+00:00Comments on JSR's RepRap Mendel: TechZone Electronics First PlayJSRhttp://www.blogger.com/profile/15313808987059484063noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-6573615209338157347.post-60300034517765663072013-11-12T16:20:18.028+00:002013-11-12T16:20:18.028+00:00My company has a mendel with a techzone kit attach...My company has a mendel with a techzone kit attached and I'm having no end of trouble actually putting it back into service. Can you provide / recommend Mainboard/Extruder Firmware and Host application that all work nicely out of the box?<br /><br />Any advice getting this working will be greatly appreciated. I've had little success getting the X/Y/Z axis to move but it's VERY unreliable.<br /><br />Thanks!!!!!!<br />Anonymoushttps://www.blogger.com/profile/02511566419919560095noreply@blogger.comtag:blogger.com,1999:blog-6573615209338157347.post-85293679955709847352013-11-12T16:18:44.264+00:002013-11-12T16:18:44.264+00:00This comment has been removed by the author.Anonymoushttps://www.blogger.com/profile/02511566419919560095noreply@blogger.comtag:blogger.com,1999:blog-6573615209338157347.post-64808927802187537622010-08-31T05:34:30.001+01:002010-08-31T05:34:30.001+01:00how did you end up powering it? did you cut the e...how did you end up powering it? did you cut the end of the power brick that they ship with the kit? i am just starting to assemble mine. do you know if it will run a makerbot?tmohttps://www.blogger.com/profile/16553162017081670373noreply@blogger.comtag:blogger.com,1999:blog-6573615209338157347.post-12742317786515355222010-06-26T02:25:30.156+01:002010-06-26T02:25:30.156+01:00I think the COM port needing to be changed is just...I think the COM port needing to be changed is just a matter of life. When I connect my techzone motherboard to the linux system I am using the serial port which gets allocated can change depending on how long the system has been unplugged from the computer. I have got used to having to change ports in application configurations and I suspect many others have as well so this is why it may not have got into the build instructionsDavid M Johnsonhttps://www.blogger.com/profile/12204013077756031068noreply@blogger.com